This is the plexi LED holder that will replace the bulb, socket and reflector below

This is the tail light I will use. It is not a perfect example since I don't want to hack on a pristine light. It has an LED 1157 bulb in it that I was going to use

In keeping with my Goldwing theme on my Goldwing I have decided to use the original mirrors but not in their original location. I did have some smaller stock looking round mirrors mounted below the handlebars which is a perfect location because you look back past the narrowest part of your body (unless you are a Harley guy). In the stock location I am always trying to see past my shoulders. So... I am making bar end mirrors out of the stock mirrors. I have cut the stems down and rethreaded them and welded corresponding nuts into the ends of the handlebars

The bike has been at oVc to have the rear caliper rebuilt and I had Ken put on this stainless steel Motad exhaust since the original is rotten. It is much lighter than the stock exhaust

Another copy of the LED template has been spray glued to a piece of plexi and cut out and drilled for 5mm LEDs.