Fiberglassing done. All that hard work on the plug is now lying on the ground

Rode to oVc in Hillsburgh to change the engine oil and rear drive oil

Spray glue and tin foil for a separator

Here is the cardboard and drywall compound plug that I made on the bike. The three depressions on the top will accommodate nuts to hold the seat pan on. The square depressions just ahead of the butt stop go down to the frame and will be supports for the back of the seat like the cafe seat previously. The depressions at the front of the plug go down to the stock seat bracket and to a tongue that goes under this bracket like the stock seat. The depressions on the side toward the back will accommodate nuts which will hold the back of the cowl with bolts through the holes in the frame that the stock fender was mounted to. The depression at the back will accommodate the back of the light